HP StorageWorks MPX200 Solution Manual page 49

5. Select one LUN. (From the selected source array, the CLI lists the LUNs that have been exposed
to the MPX200 for migration, and prompts you to select one LUN #.
6. The CLI lists the destination arrays that you have previously defined, and prompts you to select
one.
7. From the selected destination array, the CLI lists the LUNs that have been exposed to the MPX200
for migration, and prompts you to select one LUN.
The destination LUN you select should not be a part of any other job, and its size should be equal
to or greater than the source LUN.
The MPX200 warns you if it detects any valid metadata on the destination LUN. However, you
can continue and use the LUN for migration if you are aware of the consequences and want to
continue with the job scheduling.
8. At the prompts, specify the I/O size, job name, migration group, and scheduling type.
a. Enter an I/O size between 32 K and 1 MB to optimize migration performance based on
the storage array under consideration.
b. (Optional) Enter a job name (maximum 64 characters) to identify the job.
c. Select one of the listed available migration groups.
d. Select a Migration Start Time: (1=Now, 2=Delayed,
3=JobSerialScheduling, 4=ConfigureOnly).
• If you choose Delayed, the CLI prompts you to input the date and time to begin job execution.
• If you choose JobSerialScheduling, the CLI prompts you to assign a priority level at which the
job should be started when all the serial scheduled jobs start execution. The priority can range
from 1 to 256. The jobs with priority 1 are executed before the scheduler executes jobs with
priority 2.
The CLI informs you if the migration job is created successfully, and saves any changes you have
made. The MPX200 then schedules a migration job based on your inputs.
The following shows an example of scheduling an individual data migration job in the CLI:
MPX200 <1> (admin) (miguser) #> migration add
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
Index WWPN, PortId
----- ---------------------------------
0 20:78:00:c0:ff:d5:9a:05, 00-00-00
1 50:00:1f:e1:50:0a:e1:49, 82-07-00
2 50:06:01:60:4b:a0:35:de, 82-03-00
3 50:00:1f:e1:50:0a:37:18, 00-00-00
Please select a Source Target from the list above ('q' to quit): 2
Index (VpGroup Name)
----- --------------
1 VPGROUP_1
2 VPGROUP_2
3 VPGROUP_3
4 VPGROUP_4
Symbolic Name
--------------------
HP MSA2012fc-0
HP HSV200-1
DGC RAID-2
HP HSV210-3
MPX200 Multifunction Router Data Migration
Target Type
------------
Src+Dest
Src+Dest
Src+Dest
Src+Dest
49