Setting The Array Bandwidth; Setting Array Properties: Target Type - HP StorageWorks MPX200 Solution Manual

4. From the Target Type list, select Source, as shown in
Figure 14 Setting array properties: target type
.
5. To save your changes, click Save.
6. In the Security Check dialog box, enter the administrative password. (The default password is
migration.)
The mpx Manager displays a message indicating that the array properties have changed.
7. Click OK to close the message box.
8. To apply the changes and update the window before changing other array properties, click
Refresh.

Setting the array bandwidth

After you have changed the Target Type to Source, saved your changes, and refreshed the mpx
Manager (see
an additional property, Array Bandwidth. Follow the procedure in this section to change the array
bandwidth setting for data transfers.
NOTE:
The array bandwidth displays and is editable only if the array target type is Source.
42 Using DMS for data migration
Creating a data migration job group in the
Figure 14.
GUI), the right pane for the array shows