Set Fc - HP StorageWorks MPX200 Solution Manual
Hp storageworks mpx200 multifunction router data migration solution guide (5697-0701, october 2010)
Hide thumbs
Also See for StorageWorks MPX200:
- User manual (282 pages) ,
- Quickspecs (17 pages) ,
- Release note (8 pages)
Table of Contents
Advertisement
set fc
Sets the port status and programmed connection status
Session: admin
Example:
MPX200 (admin) #> set fc
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
WARNING:
The following command might cause a loss of connections to both ports.
Configuring FC Port: 1
-------------------------
Port Status (0=Enable, 1=Disable)
Link Rate (0=Auto, 1=1Gb, 2=2Gb, 4=4Gb, 8=8GB)
Frame Size (0=512B, 1=1024B, 2=2048B)
Execution Throttle (Min=16, Max=65535)
All attribute values for Port 1 that have been changed will now be saved.
Configuring FC Port: 2
-------------------------
Port Status (0=Enable, 1=Disable)
Link Rate (0=Auto, 1=1Gb, 2=2Gb, 4=4Gb, 8=8GB)
Frame Size (0=512B, 1=1024B, 2=2048B)
Execution Throttle (Min=16, Max=65535)
All attribute values for Port 2 that have been changed will now be saved.
112
Command line interface
[Enabled
]
[Auto
]
[2048
]
[256
]
[Enabled
]
[Auto
]
[2048
]
[256
]
Advertisement
Table of Contents
