Sony Handycam DCR-PC9 Operating Instructions Manual page 96

Audio dubbing
(1) Insert your recorded tape into your camcorder.
(2) Set the POWER switch to VCIL
(3) Locate the recording start point. Press the _/IP- to start playing back. To
pause playing back, press the _/| | at the recording start point. You can fine
adjust the recording start point by pressing _ / [_], and you can also use
the Remote Commander for this operatrion.
(4) Press FN and select PAGE3.
(5) Press A DUB CTRL to display control buttons.
(6) Press AUDIO DUB. The green = | | appears on the LCD screen.
(7) Press [_ on your camcorder and at the same time start playing back the
audio you want to record.
The new som_d is recorded in stereo 2 (ST2) during playback. During
recording new sound, the red = appears on the LCD screen.
(8) Press [_B on your camcorder at the point where you want to stop recording.
_ AUDIOI_I_DUB 3
96
To play back the sound
Adjust tho balanco betweon the original sound (ST1) and tho now sound (ST2) by
selecting AUDIO MIX in the menu settings (p. 105).
I VCR SET _1
H i F i SOUND
A/V->DV OUTS, r & S_r2
_Tc
About 5 minutes after when you disconnect the power source or remove the battery
pack, the setting of AUDIO MIX returns to the original sound (ST1) only. The default
setting is original sound only.