Inserting A Scene From A Vcr - Insert Editing - Sony Handycam DCR-PC9 Operating Instructions Manual

Inserting a scene from a VCR - Insert editing
You can insert a new scene front a VCR onto your originally recorded tape by
specifying the insert start and end points. Use the Remote Commander for this
operation. Connections are the same as on page 89 or 90.
Insert a cassette containing the desired scene to insert into the VCR.
[a]
[A]
[b] [c]
[c]
92
[A]: A tape that contains the scene to be superimposed
[B]: A tape before editing
[C]: A tape after editing
(1) Set the POWER switch to VCR.
(2) On the VCR, locate just before the insert start point [a], then set the VCR to the
playback pause mode.
(3) On your calncorder, locate the insert end point [¢] by pressing _ or ll,,_.
Then set it to the playback pause mode.
(4) Press ZERO SET MEMORY on the Remote Commander. The ZERO SET
MEMORY indicator flashes and the end point of the insert is stored in
inemorv.
(5) On your calncorder, locatethe insert start point [b]by pressing_,9_. Press FN
and select REC CTRL in PAGE3. Press REC PAUSE.
(6) First press ! ! on the VCR, and after a few seconds press REC START on your
calncorder to start inserting the new scene.
Inserting automatically stops near the zero point on the tape counter. Your
calncorder automatically returns to the recording stop mode.
4
ZERO SET
MEMORY
5H 6 REC CTRL