Table of Contents
Advertisement
RECORDING
g'a N I MUI [flilk k Jk
11 E
'[li
Ok'1 i) li ,qI [N
KIll)
,qi) K [H
* Please refer to the connection
you are using,
through pages 10, 11, or 12 on "ANTENNA/CA-
BLE CONNECTIONS"
before continuing.
• The "PWR." and the "VCR" indicator must appear
on the VCR's digital display.
• Turn on the TV and set the TV to channel
3 or 4. Now set the CH3/CH4 switch on
the back of the VCR to match the channel
[Back of
selected on the 'IV.
theveal
• Insert a cassette tape with its erase prevention tab in
place. (If necessary, rewind or fast forward the tape
to the point at which you want to begin recording.)
• You must select the recording mode in TV SIEREO
or SAP when you record a broadcast. Refer to "SE-
LECTING THE MTS SYSTEM" on page 18.
1
Select the channel to be (
CH32 "_
recorded
J
Pressthe numberbuttonson the
remote control or the CHAN-
NEL • or • button.
NOTE: ffyou have a cable box or satenite box connected
to this VCR, please refer to "ANTENNA/CA-
BLE CONNECTIONS" on pages 11 and 12 be-
fore proceeding to the next step.
2
Select the tape speed
f
Press the TAPE SPEED butte•
to select the desired tape speed
(SP/LP/SLP).
_P
3
Begin recording
I "Ec
L
Press the RECORD butte•. The
"REC" indicator appears on the
display.
_,
NOTE:
If any menu is activated on the TV screen, the
RECORD button on the remote control does
not function.
Press the RESET/EXIT button
to clear the menu. Then, press the RECORD
button.
m_N_
4
Stop recording
Press the STOP button when recording is completed.
Press the PAUSE/STILL
button
to temporarily
stop recording.
Press the PAUSE/STILL
or RE-
CORD button to resume
record-
rag.
I° I
NOTE:
When the VCR is in the Pause mode, you may
view the time remaining with • marks on the
TV screen. Each • mark represents one min-
ute. After five minutes, the VCR will automat-
ically switch to the Stop mode to prevent tape
damage. When there is 1 minute remaining,
one • will flash.
You can record one program while viewing another. To
start recording, follow steps [ 1] to [3] under "VIEWING
AND RECORDING THE SAME PROGRAM".
To select the channel you want to view at the TV, follow
the steps below.
NOTE: ff you have a cable box or satellite box con-
nected to this VCR, please refer to "AN-
TENNA/CABLE CONNECTIONS" on pages
11 and 12 before proceeding to the next step.
4
Select the TV mode
Press the VCR/TV button so that the "VCR" indicator
on the VCR's digital display disappears.
5 Select the channel on the TV
Set the TV to the channel you want to watch.
1
Select the VCR mode
Press the VCR/TV button so that the "VCR" indicator
appears on the display.
2 Select channel 3 or 4 on the TV
Turn on the TV and set the TV to channel 3
or 4. Now set the CH3/CH4 switch on the
LT LT3
back of the VCR to match the channel
[Back o f
selected on the TV.
theVCR]
- 24 -
EN
8F23
Advertisement
Table of Contents
