Table of Contents
Advertisement
4
set
the
tape
speed
i
......
oc_
1
Press the PLAY/A or STOP/V
_k_,_,**_}_ '%_
button until the desired
tape
_7_'_'%_ 3° _
speed appears. (Example: SP)
._c_,_-
_* j
I(Ol illl
li lillllll
Il!lilIl'lfl
5 Cheek thai the program information
is correct
• There are cases in which the program information
does not match your area. If the incorrect information
appears, select the number you want to change using
the REW/<I button. Then, enter the correct numbers
using the PLAY/& or STOP/V button.
Remember:
• If your cable box or satellite box is connected as in
Fig 4 on page 11 or Fig 5 on page 12, the local channel
number (USER CH.) must be channel 3 or 4 for every
guide channel number (GUIDE CH.). Then, set your
cable box or satellite box to the channel you want to
record; leave your cable box or satellite box on for
the timer recording.
iiiiiiii
6
Exit the VCR Plus+ set up mode
Press the RESET/EXIT button,
To set another program, repent steps [1] to [6].
i1,1 ,,
7
Set the timer
Press the POWER button to tam off. The "[]" indicator
appears on the VCR's digital display.
• Please see "HINTS FOR TIMER RECORDING" on
page 33 for more information.
You may set the VCR to start and end recording one
program within 24 hours by simply pressing the TODAY
TIMER REC, START and END buttons on the VCR.
In the example below, the Today Timer is being set to
record (current time is 6:00PM):
SETTING TIME
from 9:30PM to 11:00PM
CHANNEL
CH61
TAPE SPEED
SP
• This function cannot be done by the remote con-
trol.
• VCR power must be on to program it.
• Turn on the TV and set the TV channel
to the same video output channel as lo-
cated on the back of the VCR. (CH3 or [_ek of
4)
theVCR]
• Press the VCR/TV button so that the "VCR" indica-
tor appears on the VCR's digital display.
• Clock must be set to the correct time and date before
setting the timer.
• Insert a cassette tape with its era_ prevention tab in
place. (If necessary, rewind or fast forward the tape to
the point at which you want to begin recording.)
• Today Timer Recording controls program number 8.
Avoid overlap of programs
...
There is a case that a program will be recorded partially
or not be performed when programs overlap:
• The program with an earlier start time has priority.
Once the earlier program finishes, the overlapping
programs will begin recording in sequence.
Program 1
Program 2
'
'
I
Pmgr_
3
'
I
J
I
t
I
9:00AM
1O:O0AM
11:00AM
In case of Today Timer Recording is set,Today Timer
Recording has priority to other programs as iUustrated.
Program 1
Program 2
Program 8
'
(Today Timer) :
9:00AM
I 0:00AM
11:00AM
- 31 -
EN
8F23
Advertisement
Table of Contents
