Table of Contents
Advertisement
COPYING
A VIDEO TAPE
You can make copies of video tapes made by friends or relatives for your enjoyment.
Warning:Unauthorized
recordings of copyrighted video tapes may be an infringement of copyright laws.
Connect the editing (recording) VCR, source (playing) VCR and your TV using the following diagram.
NOTES:
• You can use the audio and video input jacks on the front panel of the editing (recording) VCR instead of using
the jacks on the back.
• When you connect a monaural VCR(another source) to this VCR, connect the Audio output jack of the monaural
VCR(another source) to the AUDIO IN L jack of this VCR. The audio signal will be recorded in both L and R
channel equally.
Fig.lO:
Audio/Video cables
(not supplied)
IConnection 11
[Editing(Recording) V CR]
[TV set]
(Usefor monitodng)
Coaxialcable
(supplied)
[Source (Playing) VCR <HIFI>[
Audio/Video cables
[Editing (Recording) VCR]
LConnection2J
Coaxial cable
(supplied)
[Source (Playing)VCR <Monaural>]
[TV set]
(Use for rnonitodng)
1) Insert a pre-recorded video cassette into the source
(playing) VCR.
2) Insert a blank video cassette, or one you want to re-
cord over, into the editing (recording) VCR cassette
compartment.
3) Press the TAPE SPEED button on the editing (re-
cording) VCR to select the desired recording speed
(SP/LP/SLP).
4) Select the "LI" or "L2" position on the editing (re-
cording) VCR. See page 13, under "Connecting to
input jacks".
5) Press the REC button on the editing (recording)
VCR.
6) Begin playback of the tape in the source (playing)
VCR.
• For best results during dubbing, use the VCR's front
panel controls whenever possible. The remote con-
tml might affect the playback VCR's operation.
Always use video-quality shielded cables with RCA-
type connectors. Standard audio cables are not rec-
ommended.
• You can use a video disc player, satellite receiver, or
other audio/video component with A/V outputs in
place of the playback VCR.
• If video or color fades in and out, you may be copying
a copy guarded video tape.
TO MONITOR
THE RECORDING
1) Turn on the TV and set the TV to channel Icm cml
3 or4. Now set the CH3/CH4 switch on
[Back of
the back of the VCR to match the channel
theVCR]
selected on the TV.
2) Press the VCR/TV
button on the editing (recording)
VCR
so that the "VCR"
indicator
appears
on the
VCR's
digital display.
- 35 -
EN
8F23
Advertisement
Table of Contents
