Values - Lexmark X342N - Multi Function Printer Service Manual

7003-XXX

Values

In the table below, the values for common variables are listed below:
•
media source
10=Multipurpose tray (MPT)
11=Tray 1
12=Tray 2
13=Tray 3
80=Duplex unit
•
media size
1=Letter
2=Legal
3=B5
4=A4
5=Executive
6=A5
7=Custom size
9=7¾ in. envelope
A=#9 Envelope
B=#10 Envelope
C=8.661 in. Envelope
D=C5 Envelope
E=B5 Envelope
F=Legal envelope
Sub error codes
First 6 bytes sub
error code data
(xx can be any
value)
84 xx 02 x1
x2
84 xx 00 x1
x2 x3
84 xx 05 x1
2-14
Service Manual
Explanation
Paper jam around input sensor
Paper is over the input sensor too long.
(x1=media size, x2=source)
Possible causes are:
• Multi sheet feeding.
• Paper size is not the same as expected.
• The media feeding from the source is slipping or media is slipping
before exiting the input sensor.
This code indicates that the input sensor is still actuated from the first
sheet and the second sheet is ready to arrive at the sensor.
(x1=media size, x2=media source)
• Check the MFP input sensor and flag for correct operation. The flag
should operate freely.
• Check for debris in the area of the input sensor.
• Check the area of the transfer roll and input to the fuser for anything
that might cause the paper to remain over the input sensor.
There was media at the input sensor too early. There was not enough
time between printhead start and the printhead mirror motor to lock.
Possible causes for this error are:
• Paper might be pre-staged in the paper source tray.
• Paper is picking too fast due to faulty paper feed assembly.
• A defective input sensor.
manuals4you.com manuals4you.com
Possible
error
message
200.00
200.01
200.02
200.04