Status And Error Messages; The Messages - Epson Action Laser II User Manual

Status and Error Messages

If an error occurs, your best source of information is the display on
the control panel. The messages displayed there tell you what may
be wrong and, in some cases, indicate the actions you should take to
correct the problem. Status messages appear on the display during
normal operation. They indicate the printer's current status.
This section contains an alphabetical list of status and error messages
you may encounter while printing and includes steps you can take
to correct any problems.
Note: In some cases, the red
is detected. This requires you to correct
press
CONTINUE
option in SelecType is set to
automatically even though
instances, you should leave AUTO CONT set to off.

The messages

In this section of the manual, status messages are preceded by [S],
error messages are preceded by [E] and warning messages are
preceded by [W]. In some cases the message you see on your display
also shows the printer mode.
[E] ADD MEMORY FOR CH-X
This indicates
Chapter 4 for instructions on changing the RX-BUFFER SIZE or
adjusting
the
or see Appendix A for adding memory.
[E] CANCEL MANUAL FEED
This message indicates that there is no paper in
slot when you are using manual feed. See Chapter 5.
7-2
Troubleshooting
CONTINUE
to clear the error. However, if the AUTO CONT
on, some
the
there is not enough memory in Channel X. See
that
memory distribution in the INDIVIDUAL setting
light flashes when an error
problem and then
the
errors
may
problem remains. In
clear
most
manual feed
the