Status And Error Messages - Epson Aculaser C8600 Quick Reference

Status and Error Messages

This section contains a list of error messages
shown on the LCD panel, giving a brief
description of each message and suggestions
for correcting the problem. Note that not
every message shown on the LCD panel
indicates a problem.
Calibrating Printer
The printer automatically calibrates itself
when any of its covers is opened and when
there is no paper jammed inside. This is not
an error message, and will clear itself after
one minute. While the printer displays this
message, do not open the covers or turn off
the printer.
Cancel All Print Job
The printer is canceling all print jobs in the
printer memory, including jobs the printer is
currently receiving or printing. This
message appears when the
button has been pressed down for more than
2 seconds.
Cancel Print Job
The print is canceling the current print job.
This message appears when the
Cancel button has been pressed and released
within 2 seconds.
Cannot Print Duplex
The printer has encountered problems
during duplex printing. Make sure you are
using an appropriate type and size of paper
for the Duplex Unit. The problem could also
be a result of incorrect settings for the paper
source you are using. Pressing the Start/Stop
button will print the rest of the print job on
only one side of the paper. Press the
Cancel button to cancel the print job.
EPSON AcuLaser C8600 Quick Reference
Check Paper Size
Check Paper Type
Job Cancel
Check Transparency
Job
Collate was disabled
Job
The paper size setting is different from the
size of paper loaded in the printer. Check to
see if the correct size of paper is loaded in the
specified paper source.
To clear this error, select Clear Warning
from the control panel's Reset Menu. See
"How to access the control panel menus" for
instructions.
The media loaded in the printer does not
match the paper type setting in the printer
driver. Media that matches only the paper
size setting will be used for printing.
To clear this error, select Clear Warning
from the control panel's Reset Menu. See
"How to access the control panel menus" for
instructions.
You have loaded media other than
transparencies when the Paper Type setting
in the printer driver is Transparency. The
printer stops loading to prevent printer
damage. Load transparencies in the
specified paper source, then press the
Start/Stop button.
Printing by specifying the number of copies
is no longer possible due to a lack of memory
(RAM) or free disk space on the optional
Hard Disk Drive. If this error occurs, print
only one copy at a time.
To clear this error, select Clear Warning
from the control panel's Reset Menu. See
"How to access the control panel menus" for
instructions.
Status and Error Messages (1/8)