Epson Action Laser II User Manual page 80

SelecType Options
SUB CONFIG.
The submenus for the subconfiguration option are different in each
printer mode. See Using the SUB CONFIG Option later in this
chapter for information on using this option.
SYSTEM CONFIG.
This option includes these eight submenus:
FULL PRINT
T-OFFSET
1-OFFSET
MEMORY LEFT
LOAD MACRO
SAVE MACRO
DELETE MACRO
POWERON MACRO
Each submenu is explained below.
FULL PRINT
0 to 62
The default setting of 0 is sufficient for most uses of the printer, but
printing complex pages may require an increase in the setting. If the
message SET FULL PRINT appears on the display, increase this
setting. The setting (any number from 0 through 62) times 20 is
number of kilobytes (K) reserved in RAM for page composition. For
example, a setting of 5 reserves 100K. The following table
maximum setting necessary for each size of paper. The setting may
be lower than
4-16 SelecType
0
maximum, but it will never need to be higher.
the
the
the
shows