Hp Emulation Command Summary - Epson Action Laser II User Manual

Printable area
The size of the printable area for the LaserJet IIP and this printer is
the same. The maximum number of characters that can be printed
per line is also the same. However, the absolute print position may
not be exactly the same as a printout from an HP LaserJet IIP printer.
In order to match your printing to the output produced on a LaserJet
printer, you can use the T-OFFSET and L-OFFSET feature of the
SelecType Level 1 SYSTEM CONFIG option to make fine
adjustments to the print start position. However, because the offset
feature can move the printing position to a point outside of the
printable area, some of the data may not be printed.
Character clipping
If a character is partially outside the printable area, the HP LaserJet
does not print any portion of the character. Your printer prints that
portion of the character that falls within the printable area.
Paper handling
When using the printer in HP emulation mode, the paper size is not
determined by the paper cassette as it is with an HP LaserJet printer.
Use the P-SIZE option in SelecType Level 1 to set any of the fourteen
paper sizes supported by the printer. For certain nonstandard sizes
of paper, you may need to use the manual feed option described in
Chapter 5.

HP emulation command summary

This section lists the printer commands supported by HP emulation
mode. For more information on printer commands, see the Hewlett-
Packard LaserJet IIP Technical Reference Manual.
HP Emulation Mode
Printer Modes D-5