Toshiba PROSEC T1-16S User Manual page 85

Device/ Name
register
SW07 Clock/calendar (Year)
SW08 Clock/calendar (Month)
SW09 Clock/calendar (Day)
SW10 Clock/calendar (Hour)
SW11 Clock/calendar (Minute)
SW12 Clock/calendar (Second)
SW13 Clock/calendar (Week)
SW14
SW15 Peripheral support priority
SW16 Mode of special input
functions
SW17 Input filter constant
SW18 Preset values for high
SW19 speed counter
SW20
SW21
SW22 Count values for high
SW23 speed counter
SW24 High speed counter control
flags
SW25
SW26 Mode of special output
functions
SW27 Special output control flags Control flags for the pulse/PWM output
SW28 Special output frequency
setting
SW29 PWM output duty setting
SW30 Analog setting value 1
SW31 Analog setting value 2
SW32
SW33
SW34 TL-F10 send data
SW35 TL-F10 receive data
SW36 PRG port station address
SW37 PRG port parity
SW38 PRG port response delay
NOTE
(1) These devices are set by the T1-16S operating system. These devices
are read only for user.
(2) Devices marked as (down) are set in the ERROR mode. Therefore
these devices cannot be used in the user program.
6. Programming Information
Function
Lower 2 digits of the calendar year
(01, 02, ... )
Month (01, 02, ... 12)
Day (01, 02, ... 31)
Hour (00, 01, ... 59)
Minute (00, 01, ... 59)
Second (00, 01, ... 59)
Day of the week
(Sun = 00, Mon = 01, ... Sat = 06)
Reserved
Bit 8 (S158) is used to select peripheral support priority
Used to select the special input functions
Used to set the input filter constant
Used to set the preset values for high speed counters
Present count values of the high speed counters are
stored
Control flags for the high speed counters
Reserved
Used to select the special output functions
Output frequency setting for the pulse/PWM output
Pulse duty setting for the PWM output
Input value of the analog setting adjuster V0
Input value of the analog setting adjuster V1
Reserved
Reserved
TOSLINE-F10 transmission data (send to master)
TOSLINE-F10 transmission data (receive from master)
Used to set the programmer port station address
(1 to 32)
Used to set the programmer port parity (0=none,
1=odd)
Used to set the programmer port response delay time
(0 to 30: 0 to 300ms)
Basic Hardware and Function
6F3B0253
They are stored in
the lower 8 bits by
BCD code
83