I/O Wiring - Toshiba PROSEC T1-16S User Manual

4.6 I/O wiring

1. Turn off power before wiring to minimize the risk of electrical shock.
!
CAUTION
2. Exposed conductive parts of wire can cause electrical shock. Use
crimp-style terminals with insulating sheath or insulating tape to cover
the conductive parts. Also close the terminal covers securely on the
terminal blocks when wiring has been completed.
3. Turn off power before removing or replacing units, modules, terminal
blocks or wires. Failure to do so can cause electrical shock or damage
to the T1-16S and related equipment.
Refer to sections 2.4 and 3 for instructions on how to properly wire the I/O
terminals.
2
0.75mm (18 AWG) to 0.3mm
Separate the I/O signal cables from high-power cables by at least 200mm.
If expansion rack or unit is used, separate the expansion cable from the power and
I/O signal cables by or unit at least 50mm.
It is recommended to separate the input signal cables from output signal cables.
Input
signal
2
(22 AWG) wires are recommended for I/O signals.
T1-16S
4. Installation and Wiring
200mm
or more
Output High-power
signal cable
Basic Hardware and Function
6F3B0253
61