Toshiba PROSEC T1-16S User Manual page 25

I/O status LEDs:
Indicates the ON/OFF status of each I/O signal. (color: red)
SW54 setting I/O intending for an indication
value
0 (default) Basic unit (L: X000-007, H: Y020-027)
1 I/O module slot 0
2 I/O module slot 1
3 I/O module slot 2
4 I/O module slot 3
5 I/O module slot 4
6 I/O module slot 5
7 I/O module slot 6
8 I/O module slot 7
9 TOSLINE-F10 (FR112M), Low 1 word
10 TOSLINE-F10 (FR112M), High 1 word
Others Basic unit (L: X000-007, H: Y020-027)
Operation status LEDs:
Indicates the operation status of the T1-16S.
FLT
RUN
PWR
PWR Lit
(Power) (green)
Not lit
RUN (green) Lit
Blinking
Not lit
FLT Lit
(Fault) (red)
Blinking
Not lit
Mode control switch:
Controls the operation modes of the T1-16S.
H (HALT) When the switch is turned to H (HALT) side, the T1-16S stops
program execution (HALT mode). In this position, RUN/HALT
command from the programmer is disabled.
R (RUN) When the switch is turned to R (RUN) side, the T1-16S starts
program execution. This is the position during normal operation.
In this position, RUN/HALT command from the programmer is also
available.
1. System Configuration
Internal 5 Vdc power is normal.
Internal 5 Vdc power is not normal.
RUN mode (in operation)
HOLD mode
HALT mode or ERROR mode
ERROR mode
Hardware error (programmer cannot be connected)
Normal
Basic Hardware and Function
6F3B0253
Note
It indicates these at the
time of only RUN
mode.
23