Toshiba PROSEC T1-16S User Manual page 293

Error message and related information
Event
Operand error Program
type -
block No.
Pair inst error Program
type -
block No.
Peripheral LSI err Error
code
Program BCC error Illegal
BCC
RAM check error Error
address
Scan time over Scan time
Info 1 Info 2 Info 3
Address
in the
block
Address
in the
block
Error data Test data
10. Troubleshooting
Special Meaning and countermeasures
device
A register/device which is not supported by
the T1-16S is programmed. (Error down)
Correct the program.
The timer or counter register is duplicated in
the program. (Error down)
Correct the program.
The subroutine number programmed with
CALL or SUBR instruction is out of the
range. (Error down)
0 to 255
Correct the program.
Index modification is programmed for
instructions in which the index modification
is not allowed. (Error down)
Correct the program.
The combination is illegal for MCS-MCR,
JCS-JCR or FOR-NEXT instructions. (Error
down)
Correct the program.
A MCS-MCR is programmed inside other
MCS-MCR segment. (Error down )
Correct the program.
A JCS-JCR is programmed inside other
JCS-JCR segment. (Error down )
Correct the program.
S004 CPU hardware error has been detected in
S016 the power-up initialization. (Error down and
programming tool cannot be connected)
Replace the unit if the error remains after
power OFF and ON again.
S006 BCC error has been detected in the user
S030 program in the RAM. (Error down)
If the error remains after power OFF and
ON again, reload the program and execute
EEPROM write operation.
S004 In the power-up initialization, an error has
S012 detected by RAM read/write checking. (Error
down)
Replace the unit if the error remains after
power OFF and ON again.
S006 The scan time has exceeded 200 ms. (Error
S031 down)
Correct the program to reduce the scan time
or use WDT instruction to extend the check
time.
Basic Hardware and Function
6F3B0253
291