Table of Contents
Advertisement
NOTE:When
using the Dado or Molding
Head, it is
not necessary
to install the loose collar.
Refer to
instruction
sheet
packed
with
dado
or molding
head.
To replace insert.
Place insert
into insert opening
in table
and
push toward rear of saw to engage spring clip
and until keyslot in insert will drop over screw.
Tighten screw.
Do not tighten screw to the point where it will
deflect the insert.
11. EXACT-I-CUT
The "yellow"
plastic disc imbedded in the table
in front of the sawblade, is provided for marking
the location of the "sawcut"
on the workpiece.
SHOWN
WITH
HOLD-DOWN
CLAMP
(OPTIONAL
ACCESSORY)
A. Checkdisc...
if it is above table surface,
place a piece of hardwood
on top of it and tap
it down.
B. With blade 90 ° (square to table)
cut off a
piece of wood.
C. Pull miter gauge back until wood is over disc.
Using very sharp pencil, mark a line on disc.
D. With miter gauge in right hand groove, follow
same procedure
and mark another
line on
disc.
E. These lines indicate
the "path"
of the cut
(kerf) made by the sawblade.
F. When cutting
the workpiece,
line up mark on
workpiece
with line on disc.
BASIC SAW OPERATION
WORK
HELPERS
Before cutting
any wood on your saw, study all of
the "Basic Saw Operations".
Notice that in order to make some of the cuts, it is
necessary
to use certain
devices
called
"Work
Helpers" like the Push Stick, the Push Block and the
Auxiliary
Fence/Work
Support, which you can make
yourself.
After you have made a few practice
cuts, make up
these "helpers"
before starting
any projects.
Make
the "Push Stick" first.
PUSH STICK AND PUSH BLOCK
Make the Push Stick using a piece of 1 x 2, or rip one
from a wide board, say 11-1/2 in. wide, and set the
rip fence 9-7/8 in. from the sawblade.
Make the Push Block using a piece of 3/8in. and 3/4
in. plywood.
The small piece of wood 3/8 in. x 3-1/2 in. should be
GLUED to the plywood
...
DO NOT USE NAILS.
This is to prevent dulling the sawblade in the event
you mistakingly
cut into the push block.
Position the handle in the center of the plywood and
fasten together
with glue and woodscrews.
AUXILIARY
FENCE/WORK
SUPPORT
Make one using
a piece
of 3/8 in. and 3/4 in.
plywood.
Fasten
together
with
glue
and
woodscrews.
NOTE:
Since
the
Push
Block
is used
with
the
Auxilia_:y
Fence,the
4-3/4
in. dimensions
must
be
held
identical
on both
the pieces.
THESE
EDGES
MUST
BE PARALLEL
3/4 PLYWOOD
3/4 PLYWOOD
PUSH BLOCK
NOTE: All dimensions in inches
45 ° NOTCH
27
t
1-5/8
NOTE:
All dimensions
in inches.
3/8 PLYWOOD
t
_--
WORKPIECE
END
111/4
I_- 1/4
THIS
FACE AND THIS
/
EDGE MUST
BE PARALLEL
PUSH STICK
3/8 PLYWOOD
27
AUXILIARY
FENCE/
WORK
SUPPORT
NOTE:
All dimensions
in inches
Hide quick links:
Advertisement
Table of Contents
