Assembly; Assembling Steel Legs; Mounting Saw; (Containing The Following Items) - Craftsman 113.290650 Owner's Manual

HH B01t, Carriage 5/16-18 x 3/4 ............ 4
JJ Spacer, Fence Guide Bar ............... 2
KK Nut, Self Threading .................... 2
LL Screw, Thumb 5/16-18 x 1 .............. 1
MM Wrench, Hex "L" 1/8 ................... 1
MM Wrench, Hex "L" 3/32 .................. 1
MM Wrench, Hex "L" 5/32 .................. 1
NN Key, Square 3/16 ...................... 1
Loose Parts Bag No. 62752 for Legs
(Containing the Following Items):
CC Screw, Truss Hd. 1/4-20 x5/8 .......... 24
DD Lockwasher, External 1/4 .............. 24
DD Lockwasher, External 5/16 4
EE Nut, Hex 1/2-13 ....................... 8
EE Nut, Hex 1/4-20 ....................... 24
EE Nut, Hex 5/16-18 ...................... 4
FF Screw, Hex 5/16-18 x 1-1/4 ............. 4
GG Washer, 11/32 x 11/16 x 1/16 .......... 8
00 Foot, Leveling ......................... 4
ASSEMBLY
ASSEMBLING STEEL LEGS
NOTE: Steel Legs are furnished with Model
113.290650.
From among the loose parts, find the following
Hardware:
24 Truss Head Screws, 1/4-20 x 5/8 in. long (top
of screw is rounded)
24 Lockwashers, 1/4 in. External Type (approx.
dia. of hole 1/4 in.)
24 Hex nuts, 1/4-20 (approx. dia. of hole 1/4 in.)
8 Hex Nuts, 1/2-13 (approx. dia. of hole 1/2 in.)
4 Leveling feet.
Assemble the legs as shown...
1. Insert the Truss Head Screws through the holes
in the legs, then through the holes in the
stiffeners. MAKE SURE THE SCREWS GO
THROUGH THE HOLES rN THE SIDE
STIFFENERS MARKED "X".
2. Install the Iockwashers... screw on the nuts
but do not tighten until completely assembled.
3. Install leveling feet.
END
STIFFENER'
/
ASSEMBLE SCREWS
THROUGH HOLES
MARKED "X"
_SIDE STIFFENER
. 1/2 IN. HEX NUTS
MOUNTING SAW
1. From among the loose parts, find the following
hardware:
4 Hex Head Screws, 5/16-18 x 1-1/4 in, long.
4 Hex Nuts 5/16-18 (approx. dia. of hole 5/16
in.)
4 Lockwashers, 5/16 in. External Type (approx.
dia. of hole, 5/16 in.)
8 Flat Washers, (dia. of hole 11/32 in.)
NOTE: Do not lift saw by plastic housing.