Configuring The Shared Storage; Bringing Up The Existing Node - Symantec Veritas Cluster Server Installation Manual

Configuring the shared storage

Bringing up the existing node

To install and configure Ethernet cards for private network
1 Shut down VCS on Node A.
# hastop -local
2
Shut down the node to get to the
# shutdown -r now
3 Install the Ethernet card on Node A.
If you want to use aggregated interface to set up private network, configure
aggregated interface.
4 Install the Ethernet card on Node B.
If you want to use aggregated interface to set up private network, configure
aggregated interface.
5
Configure the Ethernet card on both nodes.
6
Make the two Ethernet cable connections from Node A to Node B for the
private networks.
7 Restart the nodes.
Make the connection to shared storage from Node B. Configure VxVM on Node B
and reboot the node when you are prompted.
See "Setting up shared storage"
Bring up the node.
To bring up the node
1
Restart Node A.
2
Log in as superuser.
3 Make the VCS configuration writable.
# haconf -makerw
4 Display the service groups currently configured.
# hagrp -list
Installing VCS on a single node
Adding a node to a single-node cluster
prompt:
OK
on page 46.
145