Symantec Veritas Cluster Server Installation Manual page 96

96 Configuring VCS clusters for data integrity
Preparing to configure disk-based I/O fencing
command option verifies that the same serial number for the LUN is returned on
all paths to the LUN.
Make sure to test the disks that serve as coordinator disks.
The vxfentsthdw utility has additional options suitable for testing many disks.
Review the options for testing the disk groups (
in a file ( ). You can also test disks without destroying data using the
-f
See Veritas Cluster Server User's Guide.
Checking that disks support SCSI-3 involves the following tasks:
Verifying that nodes have access to the same disk
See "Verifying that the nodes have access to the same disk"
Testing the shared disks for SCSI-3
See "Testing the disks using vxfentsthdw utility"
Verifying that the nodes have access to the same disk
Before you test the disks that you plan to use as shared data storage or as
coordinator disks using the vxfentsthdw utility, you must verify that the systems
see the same disk.
To verify that the nodes have access to the same disk
1 Verify the connection of the shared storage for data to two of the nodes on
which you installed VCS.
2
Ensure that both nodes are connected to the same disk during the testing.
Use the vxfenadm command to verify the disk serial number.
/sbin/vxfenadm -i diskpath
Refer to the
vxfenadm
For example, an EMC disk is accessible by the /dev/sdx path on node A and
the /dev/sdy path on node B.
From node A, enter:
# /sbin/vxfenadm -i /dev/sdx
SCSI ID=>Host: 2 Channel: 0 Id: 0 Lun: E
Vendor id : EMC
Product id : SYMMETRIX
Revision : 5567
Serial Number : 42031000a
-g
(1M) manual page.
) and the disks that are listed
-r
on page 96.
on page 97.
option.