Setting Up A Node To Join The Single-Node Cluster; Installing And Configuring Ethernet Cards For Private Network - Symantec Veritas Cluster Server Installation Manual

144 Installing VCS on a single node
Adding a node to a single-node cluster

Setting up a node to join the single-node cluster

Installing and configuring Ethernet cards for private network

The new node to join the existing single node running VCS must run the same
version of operating system and patch level.
To set up a node to join the single-node cluster
1
Do one of the following tasks:
If VCS is not currently running on Node B, proceed to step 2.
If the node you plan to add as Node B is currently part of an existing
cluster, remove the node from the cluster. After you remove the node
from the cluster, remove the VCS RPMs and configuration files.
See "Removing a node from a cluster"
If the node you plan to add as Node B is also currently a single VCS node,
uninstall VCS.
See "Uninstalling VCS 5.0 RU3"
If you renamed the LLT and GAB startup files, remove them.
See "Renaming the LLT and GAB startup files"
2
If necessary, install VxVM and VxFS.
See "Installing VxVM or VxFS if necessary"
Installing VxVM or VxFS if necessary
If you have either VxVM or VXFS with the cluster option installed on the existing
node, install the same version on the new node.
Refer to the appropriate documentation for VxVM and VxFS to verify the versions
of the installed products. Make sure the same version runs on all nodes where
you want to use shared storage.
Both nodes require Ethernet cards (NICs) that enable the private network. If both
Node A and Node B have Ethernet cards installed, you can ignore this step.
For high availability, use two separate NICs on each node. The two NICs provide
redundancy for heartbeating.
See "Setting up the private network"
on page 131.
on page 154.
on page 142.
on page 144.
on page 40.