Creating a single-node cluster manually
Setting the path variable for a manual single node installation
Installing the VCS software manually on a single node
Answer
if you plan to incorporate the single node cluster into a multi-node
y
cluster in the future.
Continue with the installation.
See
"Licensing VCS"
on page 63.
Table 8-2
specifies the tasks that you need to perform to install VCS on a single
node.
Tasks to create a single-node cluster manually
Table 8-2
Task
Set the PATH variable
Install the VCS software manually and add a
license key
Remove any LLT or GAB configuration files and
rename LLT and GAB startup files.
A single-node cluster does not require the
node-to-node communication service, LLT, or the
membership communication service, GAB.
Modify the VCS startup file for single-node
operation.
Create and modify the VCS configuration files.
Start VCS and verify single-node operation.
Set the path variable.
See
"Setting the PATH variable"
Install the VCS 5.0 RU3 RPMs manually and install the license key.
Refer to the following sections:
Installing VCS on a single node
Creating a single-node cluster manually
Reference
See
"Setting the path variable for a
manual single node installation"
on page 141.
See
"Installing the VCS software
manually on a single node"
See
"Renaming the LLT and GAB
startup files"
See
"Modifying the startup files"
on page 142.
See
"Verifying single-node operation"
on page 142.
on page 47.
on page 141.
on page 142.
141