Configuring The Cluster In Secure Mode - Symantec Veritas Cluster Server Installation Manual

Configuring the cluster in secure mode

5
Choose whether to use the same NIC details to configure private heartbeat
links on other systems.
Are you using the same NICs for private heartbeat links on all
systems? [y,n,q,b,?] (y)
If you want to use the NIC details that you entered for galaxy, make sure the
same NICs are available on each system. Then, enter
If the NIC device names are different on some of the systems, enter
the NIC details for each system as the program prompts.
6 Verify and confirm the information that the installer summarizes.
If you want to configure the cluster in secure mode, make sure that you meet the
prerequisites for secure cluster configuration.
The installvcs program provides different configuration modes to configure a
secure cluster. Make sure that you completed the pre-configuration tasks for the
configuration mode that you want to choose.
See "Preparing to configure the clusters in secure mode"
To configure the cluster in secure mode
1
Choose whether to configure VCS to use Symantec Product Authentication
Service.
Would you like to configure VCS to use Symantec Security
Services? [y,n,q] (n) y
If you want to configure the cluster in secure mode, make sure you meet
the prerequisites and enter
If you do not want to configure the cluster in secure mode, enter
You must add VCS users when the configuration program prompts.
See "Adding VCS users"
2 Select one of the options to enable security.
Select the Security option you would like to perform [1-3,q,?]
Review the following configuration modes. Based on the configuration that
you want to use, enter one of the following values:
Installing and configuring VCS 5.0 RU3
.
y
on page 71.
Installing and configuring VCS
at the prompt.
y
. Provide
n
on page 29.
.
n
69