Setting Up The Hardware - Symantec Veritas Cluster Server Installation Manual

122 Adding and removing cluster nodes
Adding a node to a cluster

Setting up the hardware

Tasks that are involved in adding a node to a cluster (continued)
Table 7-1
Task
Install the software
manually.
Add a license key.
For a cluster that is
running in secure mode,
verify the existing security
setup on the node.
Configure LLT and GAB.
Add the node to the
existing cluster.
Start VCS and verify the
cluster.
Figure 7-1 shows that before you configure a new system on an existing cluster,
you must physically add the system to the cluster.
Reference
See "Preparing for a manual installation when adding a node"
on page 123.
See "Installing VCS RPMs for a manual installation"
on page 124.
See "Adding a license key"
See "Setting up the node to run in secure mode"
See "Configuring LLT and GAB"
See "Adding the node to the existing cluster"
See "Starting VCS and verifying the cluster"
on page 125.
on page 126.
on page 128.
on page 130.
on page 131.