If you have any trouble using your power-on password, try the
following:
1. If you think you know the correct password, reset the
computer and try again. See Chapter 3 for instructions.
2. If you know the current power-on password but you want to
change or delete it, see Chapter 3 for instructions. (You
cannot delete a power-on password and remain in network
server mode.)
3. If you do not know the current power-on password and you
do not want to set a new one, see "Removing a Password"
below.
4. If you do not know the current power-on password and you
want to set a new one, see "Setting a New Password" below.
Removing a Password
If you have forgotten your password and you do not want to set
a new one, there are two ways to remove the current password:
To do either of these procedures, you must reset a jumper on the
main system board.
Note
you are using network server
If
and you remove the
mode
Troubleshooting D-9