Removing a Password
If you have forgotten your password and you do not want to
set a new one, there are two ways to remove the current
password:
To do either of these procedures, you must reset a jumper on
the main system board.
If you are using network server mode and you remove the
password, the computer automatically turns off network
I
You should disable the existing password if you want to be able
to set a new password later without having to reset a jumper.
See "Disabling an existing password," below, for instructions.
If you disable the password function, you cannot set a new
password unless you disable the existing password at that time.
If you do not want to use a password anymore, follow the
instructions under "Disabling the password function" below.
Disabling an existing password
If you do not know your power-on password and do not want
to set a new one, follow these steps to disable the existing
password:
1. Turn off the computer. Then follow the instructions under
"Changing the Jumper Settings" in Chapter 6 to disable the
password function by setting jumper JP5 to position A.
.
Troubleshooting
,
B-11