Epson 3865X Plus User Manual page 57

7. If the configuration of the hard disk you are installing does
not match one of the drive types listed in the Hard Disk
Drive Types table, highlight User defined and press
Enter. You
Number of cylinders
The same parameter is highlighted on the submenu above.
Enter the correct number of cylinders and press
The information for
automatically updated on the submenu above and you see
the next parameter,
correct number of read/write heads for the hard disk and
press
Follow this same procedure for each remaining item in the
settings list (the number of sectors, the precompensation
cylinder, and the landing zone).
If you enter a parameter incorrectly, press t or J to
highlight the parameter and then enter it again.
The Setup program does not allow you to enter the total
storage capacity; it calculates the storage capacity for you
based on what you enter for the number of cylinders, heads,
and sectors.
After you type the landing zone number and press
the cursor block returns
8. If you want to change the hard disk settings for drive 2,
press + and return to step 4.
2-22 Running the Setup Program
see the following:
Number of heads.
Enter.
Number of cylinders
to the Drive submenu
977
Enter.
is
Enter the
Enter,
heading.