Protocol/ Baud Rate Setting (Dip Sw1-9~10) - Speco HTSD10X Instruction Manual

DIP SWITCH SETTING
A-3. PROTOCOL
th th
7 ~8 dip switches are used for Protocol Setting.
Factory Default: Pelco-D or Pelco-P ( Auto detection)
DIP SW1- 7
OFF
A-4. BAUD RATE SETTING
th
The 9 Dip Switch is used for BAUD RATE setting.
DIP SW can be changeable to 2400bps, 9600bps.
Factory Default: 2400bps.
DIP SW1 9
.
A-5. 485 TERMINATIONS
th
10 Dip Switch is used for 100Ω termination.
th
Set on 10 Dip Switch only for the last looped camera from the controller.
Even in case of only one camera, set on 10
DIP SW1- 8
OFF
th
OFF
ON
th
Pelco-D or Pelco-P
BAUD RATE
2400
9600
Dip Switch of the cameras.
26