Cf_Vpos Command; Cf_Hscale Command - Sanyo PLC-XC56 - 3100 Manual

PLC-XC56 Expand Serial Command Functional Specifications
8.7.6

CF_VPOS Command

Command "CF_VPOS_%1"[CR]
"015" --------- +15
"014" --------- +14
ÿ
"002" --------- +2
"001" --------- +1
"000" --------- +0
%1 "-01" ---------- -1
"-02" ---------- -2
ÿ
"-14" ---------- -14
"-15" ---------- -15
"UP" ---------- Vertical Position setting value + 1
"DN" ---------- Vertical Position setting value – 1
Set Vertical Position
This command is available in normal Power ON status.
Details Note1) When Screen setting is not in Custom mode, projector changes image
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not excute..
Acceptable
Response
Unacceptable
8.7.7

CF_HSCALE Command

Command "CF_HSCALE_%1"[CR]
"032" --------- +32
"031" --------- +31
ÿ
"002" --------- +2
"001" --------- +1
"000" --------- +0
%1 "-01" ---------- -1
"-02" ---------- -2
ÿ
"-31" ---------- -31
"-32" ---------- -32
"UP" ---------- Horizontal Scale setting value + 1
"DN" ---------- Horizontal Scale setting value - 1
Set Horizontal Scale
This command is available in normal Power ON status.
Details Note1) When Screen setting is not in Custom mode, projector changes image
mode into Custom by receiving this command.
Note2) When there is no signal detected, projector returns 101 and the command
does not excute.
Acceptable
Response
Unacceptable
"000"[CR]
"Error Code"[CR]
"000"[CR]
"Error Code"[CR]
27 / 65