Cf_Coltemp Command; Cf_Nzred Command; Cf_Progv Command; Cf_Image Command - Sanyo PLC-WTC500AL - 5000 Lumens Manual

PLC-WTC500L Expand Serial Command Functional Specifications

8.4.8 CF_COLTEMP Command

Command "CF_COLTEMP_%1" [CR]
"000" ------------------------------ Xlow
"001"------------------------------- Low
%1
"002"------------------------------- Mid
"003"------------------------------- High
Set Color Temperature (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector's memory.
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.4.9 CF_NZRED Command

Command "CF_NZRED_%1" [CR]
"OFF" ---------------- Cancel Noise Reduction
"L1" ------------------- Set Noise Reduction L1
%1 "L2" ------------------- Set Noise Reduction L2
"UP" ------------------ Toggle between ON and OFF. (OFF→L1→L2→OFF...)
"DN" ------------------ Toggle between ON and OFF. (OFF→L2→L1→OFF...)
Set Noise Reduction level (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector's memory
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It returns to the original setting in Suspend mode as well.)
Acceptable
Response
Unacceptable

8.4.10 CF_PROGV Command

Command "CF_PROGV_%1" [CR]
"OFF" -------------- Set Progressive scan to OFF.
"L1" ----------------- Set Progressive scan to L1 (for movie image).
"L2" ----------------- Set Progressive scan to L2 (for still image).
%1
"FILM" ------------- Set Progressive scan to Film.
"UP" ---------------- Switch setting forward direction (OFF→L1→L2→FILM→OFF)
"DN" ---------------- Switch setting backward direction (OFF→FILM→L2→L1→OFF)
Set Progressive scan mode. (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector's memory.
Details
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Suspend mode.)
Acceptable
Response
Unacceptable

8.4.11 CF_IMAGE Command

Command "CF_IMAGE_%1" [CR]
"DYNAMIC" ---Dynamic (Fixed value to enable projection with a sharp, powerful
"STAND" -------Standard(Image adjust value is set to factory default for Still Image)
"REAL---------- Real (Fixed value to display graphic image with natural tone)
%1
"CINEMA"----- Cinema (Fixed value to focus on tone reproduction for movie)
"CUSTOM1" ------------- Image1 ÿ the value adjusted and stored by userÿ
"CUSTOM2" ------------- Image2 ÿ the value adjusted and stored by userÿ
"CUSTOM3" ------------- Image3 ÿ the value adjusted and stored by userÿ
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
"000" [CR]
"Error Code" [CR]
picture tone)
19/75