Notes On Connections - Panasonic PT-L711U Operating Instructions Manual

Connections
Notes on connections
* Read the instruction manual for each system component carefully before
connecting it.
€ Turn off the power supply for all components before making any
connections.
e if the cables necessary for connecting a component to the system are not
included with the component or available as an option, you may need to
fashion a cable to suit the component concerned.
e |f there is a lot of jitter in the video signal which is input from the video
source, the picture on the screen may flicker. In such cases, it wil! be
necessary to connect a TBC (time base corrector).
è The projector has built-in speakers. However, you will need to connect a
separate audio system to the AUDIO OUT jack if your needs specify high
sound volumes. No sound will come out of the projector's built-in speakers
while the AUDIO OUT jack is being used.
® |t may not be possible to connect some types of computer. Refer to the list
of compatible signals on page 50.
e The pin layout and signal names for the S-VIDEO IN connector are shown
below.
Ground (Luminance signal)
Ground (Color signal)
Color signal
Prepa
External view
e The pin layout and signal names for the RGB/YPBPR (RGB1 IN/RGB2 IN)
connector are shown below.
| PinNo. | Signal «— —
[ Q pma — ooo
Pin (9) is spare.
Pins @ 8), (D and @ are for ground.
Pins @ and (5 functions are only valid when
supported by the computer
External view
S
17