Oki C130n Instruction Manual page 83

Note It is not possible to exit REMOVE ALL mode before the operation is
finished (even if the Cancel key is pressed).
If the printer has incorrectly been switched to REMOVE ALL mode,
open, then close the front cover four times to exit REMOVE ALL
mode.
2
Perform the operations described in steps 2 through 10 of "Replacing a
Toner Cartridge" starting on page 6-77 to replace the magenta toner
cartridge.
3
Follow the same procedure to replace the cartridges for the cyan, black,
then yellow toners.
Note The printer must complete a calibration cycle (less than 2 minutes)
after a toner cartridge has been replaced. If you open the top or
front cover before the printer is reset, the calibration stops, then
starts over again after the cover is closed.
4
Press the key three times to exit the configuration menu.
83 - C130n User's Guide