Oki C130n Instruction Manual page 143

Symptom Cause
Printing The printer is set to a slow
takes too printing mode (for example,
much time. thick stock).
The printer is set to power
saving mode.
The job is very complex.
A toner cartridge for a
different region is installed
(
X INCORRECT
displayed in the message
window).
Blank pages One or more of the toner
are printed. cartridges are defective or
empty.
The wrong media is being
used.
Printer The printer was in the
returned to configuration menu structure
without a selection being
IDLE before
made within two minutes.
the
configuration
menu was
changed.
Not all pages The Cancel key was
print. pressed.
The tray is empty.
A document is printed with
an overlay file which has
been created by a
non-suitable driver.
Printer The power cord is not
resets or correctly plugged into the
turns off outlet.
frequently.
A system error occurred.
Solution
It takes more time to print with special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
It takes time for printing to start in
power saving mode.
Wait. No action needed.
Install a genuine Oki toner cartridge
approved for your specific printer.
is
Check the toner cartridges. The image
will not print correctly or not at all, if a
cartridge is empty.
Check that the media type set in the
driver matches the media loaded in the
printer.
When in the configuration menu
structure, select your choice within
2 minutes.
Make sure no one pressed the Cancel
key while your job was printing.
Check that the tray is loaded with
media, in place, and secure.
Print the overlay file using a suitable
driver.
Turn off the printer, confirm that the
power cord is correctly plugged into the
outlet, and then turn on the printer.
Contact Technical Support with the
error information.
143 - C130n User's Guide