Furuno FELCOM 16 Operator's Manual page 40

2. SYSTEM INITIALIZATION
Note: The terminal unit must be "idle" to login. ("Current State: IDLE"
4. Yes is selected; press the [Enter] key to start login.
5. Login begins and the screen should now look something like the illustration
below, with "LOGIN" flashing.
File
Current State: LOGIN
CALLING
DCE F16 Ver. **
When login is completed, the message "Successful login." appears. Then,
the terminal unit goes into "Idle" status and LOGIN stops blinking.
6. Press any key to return to the standby display.
2-6
appears at the bottom of the screen.) When it is not idle, "Ignored:
MES is not idle." appears. Press the [Esc] key to return to the standby
display. Wait until the terminal unit becomes idle.
Edit Transmit EGC
Options
Login
Starting Login Process.
Press any key to escape.
LOGIN replaces IDLE.
Appearance of display screen during login
Reports Logs Options
Flashing during login
SYNC ( NCS )
NCS: IOR LOGIN
Setup Position StopAlarm
02-02-25 02:02 (UTC)
LAT: 34:30.00N
LON: 135:30.00E