Table of Contents
Advertisement
Installing rack-server in/removing from rack
3.5.2 Installing the slide-in module
The server requires five height units. The sliding rails are mounted in the bottom height unit. One
height unit is equal to 4.445 cm = 1 ¾ inches.
Fitting spring nuts
1
Ê
Insert the spring nuts in the corresponding groove of the support upright at the mounting points
for the sliding rails and the server (1 - 4).
Ê
If necessary, adjust the position of the nuts in the groove until they lock into the correct position
(5).
A26361-K646-Z102-1-7619
ca 45°
2
3
4
Installation
5
5
17
Advertisement
Table of Contents
