No Mouse Pointer Displayed On The Screen; The Floppy Disk Cannot Be Read Or Written; Time And/Or Date Is Not Correct; System Does Not Boot - Fujitsu Siemens Computers PRIMERGY B120 Operating Manual

No mouse pointer displayed on the screen

7.6 No mouse pointer displayed on the screen
Mouse driver not loaded
Ê
Check whether the mouse driver is properly installed and is present when the application
program is started. Detailed information can be found in the User Guides of the mouse, the
operating system or the application program.
Mouse controller disabled
The mouse controller on the system board must be enabled, if you use the supplied mouse.
Ê
Check in the BIOS Setup that the mouse controller is Enabled.
7.7

The floppy disk cannot be read or written

Ê
Check whether the write protection of the floppy disk is activated.
Ê
In the BIOS Setup check the entry for the floppy disk drive.
Ê
Check in the BIOS Setup whether the diskette drive controller and write permission are enabled
(see the Technical Manual for the system board).
Ê
Check that the cables of the floppy disk drive are properly connected (refer to chapter
components and
7.8

Time and/or date is not correct

Ê
Set the time and/or date in the operating system or in the BIOS Setup.
If the time and date are repeatedly wrong when you switch on your server, the battery is
i
flat. Change the lithium battery as described in the Technical Manual of the system board.
7.9

System does not boot

System will not boot after installing a new SCSI hard disk drive.
SCSI configuration incorrect (standard SCSI controller)
Ê
In the SCSI configuration menu check the settings for the hard disk drives (SCSI Device
Configuration) and the settings under Advanced Configuration Options .
A26361-K646-Z102-1-7619
expansions").
Troubleshooting and tips
"System
41