Table of Contents
Advertisement
2
Important notes
In this chapter you will find information regarding safety which it is essential to take note of when
working with your server. The manufacturer's notes contain helpful information on your server.
2.1
Safety
The following safety notes are also provided in the manual "Safety, Guarantee and
!
Ergonomics", which contains additional information about guarantee and ergonomics.
This device complies with the relevant safety regulations for data processing equipment, including
electronic office machines for use in an office environment.
If you have any questions, contact your sales outlet or our customer service center.
Before operating the device
WARNING!
!
During installation and before operating the device, observe any existing instructions on
environmental conditions (see section
If the device is brought in from a cold environment, condensation may form both inside and on
the outside of the machine. Before operating the device, wait until it is absolutely dry and has
reached approximately the same temperature as the installation site. Material damage may be
caused to the device if this requirement is not observed.
Installation and operation
WARNING!
!
The server automatically sets itself to a line voltage in the range of 100 V to 240 V. Ensure that
the local mains voltage lies within these limits.
This device has a safety tested power cable and must only be connected to a properly
grounded wall outlet.
Ensure that the power socket on the device or the grounded wall outlet is freely accessible.
The ON/OFF switch does not disconnect the device from the line voltage. To disconnect the
line voltage completely, remove the power plug from the grounded power outlet.
Connect the device and the attached peripherals to the same circuit (loss of data).
Lay all cables so that nobody can stand on them or trip over them. Refer to the relevant notes
in the operating manual when connecting the device.
No data transmission cable should be connected or disconnected during a thunderstorm
(danger of lightning).
Please ensure that no objects (e. g. necklaces, paperclips etc.) or liquids can get into the
interior of the device (this may cause an electrical shock or short circuit).
In emergencies (e.g. damaged casing, elements or cables, penetration of liquids or foreign
matter), switch off the device immediately, remove the power connector and contact your
customer service center.
A26361-K646-Z102-1-7619
"Technical
data").
5
Advertisement
Table of Contents
