Chipdisk For Remoteview; Installing/Removing The Chipdisk - Fujitsu Siemens Computers PRIMERGY B120 Operating Manual

Intel-based server systems

Table of Contents

System components and expansions

8.4

chipDISK for RemoteView

To use RemoteView, the remote test and diagnosis system, on the server, a RemoteView chipDISK

is available for the PRIMERGY B120 server as an option. The RemoteView chipDISK is equipped

with an IDE interface and is mounted in the server on the side of the drive cage on two spacer

sleeves.

Exit the operating system, switch off the server and disconnect it from the power supply.

Switching off the server does not disconnect the device from the network. To completely

disconnect the device from the network, remove the power plug from the line voltage.

Open the server, and remove the side cover and the slot cover (see the chapter

closing the

server").

Connect the plug of the IDE ribbon cable to the IDE connection (2) and the small plug of the

power supply cable to the power supply connection (3) of the chipDISK board.

Make sure the jumper (1) is set to M.

Open the server (see

M S C

"Opening and closing the

chipDISK for RemoteView

server").

"Opening and

A26361-K646-Z102-1-7619

Table of Contents