Installing/Removing An Accessible 5 ¼-Inch Drive - Fujitsu Siemens Computers PRIMERGY B120 Operating Manual

Accessible drives
8.2.1 Installing/Removing an accessible 5 ¼-inch drive
Ê
Shut down the operating system.
Ê
Switch off the server, and disconnect it from the network.
Switching off the server does not disconnect the device from the network. To completely
!
disconnect the device from the network, remove the power plug from the line voltage.
Ê
Open the server (see
1
Ê
Disconnect the cables from the drive (1).
Ê
Remove the two fastening screws (2) and take out the drive toward the front (3).
The new drive is mounted in reverse order.
If you do not install a new drive, proceed as follows:
Ê
Mount an EMC insert (a) and a plastic cover (b) in the empty bay (1 + 2).
Ê
Close the server again (see
A26361-K646-Z102-1-7619
"Opening and closing the
"Opening and closing the
System components and expansions
server").
2
1
2
a
server").
3
b
49