Table of Contents
Advertisement
NTI XTENDEX Wall Mount Extenders
Connect the CAT5 cable
Make sure the CAT5 cable has been installed in accordance with the "Preparation for Installation"
instructions on page 3. Connect the CAT5 cable to the "Cat 5" port on the Remote Unit (see Fig. 6).
When properly inserted the CAT5 cable end should snap into place.
!
WARNING: Never connect the XTENDEX to an Ethernet
card, Ethernet router, hub or switch or other Ethernet RJ45
connector of an Ethernet device. Damage to devices
connected to the Ethernet may result.
Note: The yellow LED on the
RJ45 connector on the Remote
Unit will illuminate anytime data
traffic is passing between the
Local and Remote Units.
Plug-in and Power Up
1.
Plug the power cord from the monitors into power outlets. Also power up the speakers if they have external power supplies.
2.
Connect the 12VDC AC adapter power connector to the 12VDC port on the Local Unit (see Fig. 7). Plug the AC adapter into
a power outlet. The green LED on the RJ45 connector of the Remote Unit and the power LED on the wallplate of the Local
Unit should each illuminate, indicating that a proper power connection has been made to them (see Fig. 6). (The Remote
Unit is powered by the Local Unit through the CAT5 cable.)
3.
Turn ON the CPU and Monitors.
They should each react as if they
were directly connected to each
other.
VIDEO
OUT
AUDIO
OUT
NTI
R
www.nti1.com
ST-C5VA-WL500
Local Unit
(Front View)
Figure 7- Connect the AC adapter to the Remote Unit
Green
Power LED
Yellow
Traffic LED
Figure 6- Connect the CAT5 cable to the Remote Unit
VIDEO
IN
AUDIO
IN
12VDC
1A
XTENDEX
TM
VA
Local Unit
8
Front View of Remote Unit
NTI
R
Network Technologies Inc
XTENDEX
CAT5 Cable to
Local Unit
Barrel
Power Connector
12VDC @ 1.0A OUTPUT
(Outside
(Inside
barrel)
barrel)
2.1 mm x 5.5 mm Female
12VDC
AC Adapter
Advertisement
Table of Contents
