Connect The Cat5 Cable; Figure 4- Connect Stereo Speakers And Microphone To Xtendex Local Unit With Audio Support; Figure 5- Connect Cat5 Cable To Local Unit - Network Technologies ST-C5KVM2ARS-1000S Installation And Operation Manual

NTI XTENDEX Extenders
d) If the Local Unit has RS232 support, connect the local user's RS232 cable from a touch screen
monitor to the RJ45 port on the Local Unit using the DB9M-to-RJ45 adapter and patch cable provided.
e) If the Local Unit has audio support, connect the cable from the local speakers to the 3.5mm
stereo audio jack with the speaker symbol on the Local Unit. (See Fig. 4)
3.5mm stereo audio jack with the microphone symbol on the Local Unit.

Figure 4- Connect stereo speakers and microphone to XTENDEX Local Unit with audio support

Note: When two microphones are connected (one at local and one at remote), only one can be active at a time. See
mode charts on pages 12 and 13 for active microphone selection.

Connect The CAT5 Cable

Connect the CAT5 cable to the "Cat 5" port on the Local Unit. (See Fig. 5.) When properly inserted the cable end
should snap into place.
Note: If an RJ45 wall outlet is being used, connect the other
end of the extension cable to the RJ45 wall outlet.
!
WARNING: Never connect the XTENDEX to an Ethernet
card, Ethernet router, hub or switch or other Ethernet RJ45 connector
of an Ethernet device. Damage to devices connected to the Ethernet
may result.
ST-C5KVM2ARS-1000S Local Unit
Rear View
XTENDEX
Inc Technologies NTI
R
Network
Microphone
Stereo
Speakers
ST-C5KVM2ARS-1000S Local Unit
Rear View
CAT5 Cable to
Remote Unit

Figure 5- Connect CAT5 cable to Local Unit

8
Connect a microphone to the
XTENDEX
Inc Technologies Network
NTI
R
Yellow Traffic LED
Green Power LED