Installing The Local Unit; Connect The Catx Cables; Figure 2- Connect The Xtendex Local Unit To The Source; Figure 3- Connect Catx Cable - Network Technologies XTENDEX ST-C6USBH-300 Operating Manual

NTI XTENDEX 300 Foot HDMI and IR Extender

Installing The Local Unit

1. Connect an HDMI-3-MM (supplied) or DVI-HDMI-xx-MM cable (page 2) between the CPU and the "HDMI In" connector on the
Local Unit.
2. Connect a USB2-AB-1M-5T USB cable (supplied) between a USB port on the CPU and the "USB CPU" connector on the Local
Unit.

Connect the CATx Cables

Connect the CATx cable between the "CATx" ports on the Local
and Remote Unit. (See Figure 3) When properly inserted the
cable ends should snap into place.
!
WARNING: Never connect the XTENDEX to an
Ethernet card, Ethernet router, hub or switch or other
Ethernet RJ45 connector of an Ethernet device. Damage to
devices connected to the Ethernet may result.

Figure 2- Connect the XTENDEX Local Unit to the source

6

Figure 3- Connect CATx cable