NTI 4K HDMI EXTENDER OVER HDBASE-T
RS232 Cable Pinout
If an RS232 Cable is used, the following connections need to be made;
DB9F Pins
Transmitter
(Connect at
Terminal
PC (DTE ))
Block
3
T
2
R
5
G
VESA Mounting Bracket
A VESA Mounting Bracket is available (NTI PN: MK-STC6USB4KHDBT) in the event installation is being made to the back of a
flat panel monitor.
The steps for mounting the Transmitter or Receiver to the bracket are as follows:
1. Place the Transmitter/Receiver on the bottom bracket.
2. Line up the holes between the top bracket and the bottom bracket.
3. Install the flat-head countersink screws to secure the top bracket to the bottom bracket.
4. Mount the assembly to your display.
Signal
DB9M Pins
(Connect to
device (DCE))
TxD Out
RxD In
Gnd
MK-STC6USB4KHDBT Bracket Installation
Receiver
Signal
Terminal
Block
3
T
2
R
5
G
5
TxD In
RxD Out
Gnd