WARNING: The CATx connection cable used between NTI XTENDEX Series Transmitter and Receiver or any XTENDEX Series products must be wired straight through (pin 1 to pin 1, pin 2 to pin 2, etc.) The use of a CROSSOVER CABLE will damage the extender and void your warranty.
Introduction The ST-C64K18GB-197 HDMI 18Gbps Extender can extend high definition video / audio signal and one-way IR up to 197ft / 60 meters over a single Cat6/6a/7 cable (up to 164 feet (50m) with CAT5e). It supports resolutions up to 4K2K(3840x2160)@60Hz 4:4:4, 18Gbps and HDCP 2.2.
Local and Remote Units should be grounded through either a display or source that uses a 3-prong power cord. If only one unit is grounded, shielded CAT5 cable should be used. Note: CATX connection cable used between NTI XTENDEX Series Local and Remote or any XTENDEX Series products should not be run underground, outdoors or between buildings.
Features and Functions Transmitter Panel Number Name Function description HDMI OUT Connect to HDMI display device such as TV or Projector with an HDMI cable. HDMI IN Connect to HDMI source device such as DVD or PS4 player with an HDMI cable. CAT OUT Connect CAT6 cable between this and "CAT IN"...
Receiver Panel Number Name Function description HDMI OUT Connect to HDMI display device such as TV or Projector with an HDMI cable. CAT IN Connect CAT6 cable from "CAT OUT" port on the Transmitter. Power Indicator The lamp will illuminate when the Receiver is powered ON. Lamp (Green) Data signal The lamp will illuminate when the Transmitter and the Receiver have...
IR Pin Definition The IR Receiver and IR Blaster cables have pinout definition as shown below: The following illustrates the IR system and how the IR cables are used. ...
Interconnection Cable The connection cable between the Transmitter and Receiver is terminated with RJ45 connectors and must be wired according to the EIA/TIA 568 B industry standard. Wiring is as per the table and drawing below. Pair 3 Pair 2 Pair 1 Pair 4 Wire Color Pair...
WARNING: The CATx connection cable used between NTI XTENDEX Series Transmitter and Receiver or any XTENDEX Series products must be wired straight through (pin 1 to pin 1, pin 2 to pin 2, etc.) The use of a CROSSOVER CABLE will damage the extender and void your warranty.