Lead Wire Wiring Diagram - JVC LX-D1010G - Lcd Projector Service Manual

13. LEAD WIRE WIRING DIAGRAM

Clamp the lead wires along the clamping zone shown in the diagram below.
The clamping zone indicates where the lead wires are to be routed and clamped.
Cautions
* The inner wires are clamped so that they do not come close to heat generating or high voltage parts. After servicing
route all wires in their original position.
* Workers shall put on the wristband to protect LCD Panel against static electricity during the operations.
Clamping zone
Hidden clamping zone
Lead dress in the Bottom Case Unit
Cushion
A
Micro Switch
Lead wire
Cushion
Cushion
Power Earth
Cushion
A
Cushion
Bend the rest of the
cushion back.
There should be no slack in the lead
wire when the cushion is stuck.
Power Earth
Cushion
The lead wire should be fixed
firmly by the cushion.
LX-D1010G
Micro Switch
Inlet Earth
(PA012) 13-1