JVC LX-D1010G - Lcd Projector Service Manual page 48

LX-D1010G
3) Warning status
When the program starts, warning data will be acquired automatically from the projector and the results will be displayed.
The item in which an error has occurred will be checked in the check box. If the warning data cannot be acquired correctly, the
data will not be displayed in the main dialogue box.
If the warning data cannot be acquired correctly, click the [warning status] button to re-acquiring the warning status data.
4) Warning history
When the [History1], [History2] or [History3] button is clicked, the last, two times before or three times before warning data will
be acquired from the projector respectively and the results will be displayed.
The item in which an error has occurred will be checked in the check box. If the warning data cannot be acquired correctly, the
data will not be displayed in the main dialogue box.
5) Clearing the warning history
After correcting the error, perform the clearing the warning history.
When the [ALL CLEAR] button in the main dialogue box is clicked, a command will be sent from the personal computer to the
projector to clear the all of warning history and the error display will be cleared.
6) When a communication error occurs
When a message such as "No response from the projector." Is displayed, check the following items.
・ Is the main power switch of the projector turned on ?
・ Is the RS-232C cable correctly connected ?
・ Is the COM port to which the RS-232C cable is connected correctly set ?
・ Has the prescrived procedure been used to start the projector and personal computer ?
7) Saving the warning data
When the [DETAIL] button in the main dialogue box is clicked, the [DataTemp.txt] file will be opened by the NOTEPAD and
then save this file in case of need.
8) Exiting the program
Click the [CLOSE] button to exit the program.
10-2 (PA012)