JVC LX-D1010G - Lcd Projector Service Manual page 26

LX-D1010G
4.6. Removing the Power Ass'y
(1) Remove the Top Case Ass'y.(see 4.2)
(2) Remove the Lamp Power Unit.(see 4.3)
(3) Remove the (Main PWB, Video PWB, Inlet Switch PWB
and Terminal Board) Ass'y.(see 4.4)
(4) Disconnect the Connector NN of the Power Sub PWB
Ass'y.
(5) Remove 6 Screws Q and then remove the Power Ass'y.
Screws Q
4-4 (PA012)
Screws Q
4.7. Removing the Power PWB Ass'y and
the Power Sub PWB Ass'y
(1) Remove the Top Case Ass'y.(see 4.2)
(2) Remove the Lamp Power Unit.(see 4.3)
(3) Remove the (Main PWB, Video PWB, Inlet Switch PWB
and Terminal Board) Ass'y.(see 4.4)
(4) Remove the Power Ass'y.(see 4.6)
(5) Disconnect the Connector NP and then remove the
Power Sub PWB Ass'y.
Screws S
Connector NP
(6) Remove the Screw R and then remove the Power Sub
Holder.
Power Barrier
(7) Remove the Power Holder (R), (F) and the Power Barrier.
4.8. Removing the Intake Fan (Front)
(1) Remove the Top Case Ass'y.(see 4.2)
(2) Remove the Lamp Power Unit.(see 4.3)
(3) Remove the (Main PWB, Video PWB, Inlet Switch PWB
and Terminal Board) Ass'y.(see 4.4)
(4) Remove the Power Ass'y.(see 4.6)
(5) Remove the Connector NP.
(6) Remove 2 Screws S and then remove the Intake Fan
(Front) from the Power Holder (F).
Power Sub PWB Ass'y
Screw R