JVC LX-D1010G - Lcd Projector Service Manual page 50

LX-D1010G
Preferential Indicator Display
Order
POWER LAMP
2 Red/Green Green
alternately
3 Red/Green Orange
alternately
Red/Green Orange
alternately
Red/Green Orange
alternately
Red/Green Orange
alternately
Red/Green Orange
alternately
Red/Green Orange
alternately
Red/Green Orange
alternately
4 Red/Green Red
alternately
Red/Green Red
alternately
Red/Green Red
alternately
Red/Green Red
alternately
5 Red/Green Off
alternately
6 Red/Green Off
alternately
7 Red/Green Green
alternately
Red/Green Green
alternately
8 Red Off
Red Off
Red Off
9 Red Red flash
Green Red/Green
alternately
Red Red
10 Red Green flash
11 Green Green
12 Red Green flash
11-2 (PA012)
Symptom
TEMP
Red No power on IIC bus 1 failure (EEPROM)
Red No power on STBY power
flash
Red No power on SW5D power
flash 2
Red No power on SW3.3 power
flash 3
Red No power on SW15.5 power
flash 4
Red No power on SW12 power
flash 5
Red No power on SW5A power
flash 6
Red No power on SW9AU power
flash 7
Red No power on FAN STOP: Intake fan
flash
Red No power on FAN STOP: Exhaust fan
flash 2
Red No power on FAN STOP: Power unit fan
flash 3
Red No power on FAN STOP: PBS fan
flash 4
Off No power on Lamp cover open
(Power on prohibited for safety)
Filter cover open
(for dust in prevention)
Red No power on Missing thermistor
flash
Red No power on IIC bus 2 failure (DECODER)
flash 2
Red No power on AV bus failure
flash 3
Red No power on High intake air temperature (outside
flash air temperature)
Red No power on High temperature around the lamp
flash 2
Red No power on High temperature around the PBS
flash 3 (LCD)
Warning indicated by the Warning that the and of lamp's life
Off
LED during STBY span is near (1500-2000h)
Warning indicated by the Warning that the and of lamp's life
Off
LED during power on span is near (1500-2000h)
Power on prohibited due to the end
Off No power on
of lamp's life span (more than 2000h)
Off No power on for one Lamp failure
minute
Off No power off for one For one minute after power on
minute
Off No power on for one For one minute after power off
minute
Failure
PWB
Main IC705
ICLK0, IDA0
Power SD Connector
Main STBYR5 (SD-8)
Power Sub SD Connector
Main SW5D (SF-8)
Power Sub SD Connector
Main SW3.3 (SF-10)
Power SD Connector
Main SW15.5 (SD-2)
Power SD Connector
Main SW12 (SD-4)
Power SD Connector
Main SW5A (SD-6)
Power Sub SD Connector
Audio SW9AU (SV-2)
Main
Main SY Connector
Main SW Connector
Power Sub NP Connector
Main SX Connector
Power Sub SN Connector
Lamp cover
Power Sub SN Connector
Filter cover (side)
Main SZ Connector
Main IC2A2
ICLK1-45p, IDA1
Main IC700-AAD0-23
IC400-AAD0-23
Setting Room temperature not conforming
to the specification.
Setting Covered vent
Setting Clogged intake at the side.
Not a malfunction
Not a malfunction
Replace the lamp and then reset the lamp time.
(Press the [POWER], [
the same time.)
Not a malfunction
Not a malfunction
Not a malfunction
Check Point Reset
Reference
Auto
Main
Power
Main
Power
Main
Power
Main
Power
Main
Power
Main
Power
Main
Power
Main
Power
Main
Power
Main
Power
Main
Power
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Auto
Manual
Manual
Manual
] and [ ] buttons at
Auto
Auto
Auto