JVC LX-D1010G - Lcd Projector Service Manual page 4

LX-D1010G
■ ■ ■ ■ Warning and caution labels
Labels advising of warning and caution are affixed on and in various locations of the product. Take careful notice of these during service and
inspection.
WARNING
CAUTION
Class Pictorial
CAUTION High voltage
and Ultraviolet rays
CAUTION Explosion
CAUTION High Temperature
CAUTION
CAUTION High brightness
CAUTION Laser Radiation
■ ■ ■ ■ Additional cautionary items
● High voltage is applied for lighting the lamp. During adjustments and other work with the cover removed, extreme care is needed to avoid
electric shock.
● Use care to avoid touching the fan or safety switch terminals during work with the cover removed.
● Select a stable, horizontal work site to prevent dropping the product and components.
● Use the power cord and interface cable supplied with the product.
Before starting work, be sure to also check the safety notices contained in the instruction manual.
II (PA012)
Risk of lethal or otherwise serious personal injury.
Risk of personal injury and damage to the product.
1. Never open any cover on the projector except the lamp and filter covers.
Dangerous electrical voltages inside the projector.
2. Do not use this equipment when the cabinet is broken.
Harmful Ultraviolet rays may leak out.
High-pressure lamp may explode if improperly handled.
High Temperature. Do not replace the lamp for 1hour after power off.
Turn off power before opening this lamp cover. See user's manual for Replacing
the Lamp. Replace with same type lamp rated.
Do not look into the lens during operation.
LASER RADIATION
DO NOT STARE INTO BEAM
WAVE LENGTH: 640-660nm
MAX OUTPUT: 1mW
CLASS 2 LASER PRODUCT
IEC 60825-1:1993+A1:1997
Label advisory Location
Rear of
Bottom Case
Bottom of
Bottom Case
Lamp Cover
Lens Cap
Remote
Controller